Abstract
ABSTRACT Electro Chemical Discharge Machining (ECDM) has been introduced as an un-conventional hybrid process in last few decades for machining of materials which are electrically non-conducting as well as conducting. In the current work, an effort is carried out to modify the microfeatures produced in ECDM machining with a sensor mechanism. An ECDM setup is fabricated with a sensor mechanism in order to reduce the irregularities in the micromachining process. The microholes machined with a sensor mechanism has shown improvement in terms of circularity. A multiobjective optimisation is carried out with Grey Fuzzy Reasoning Analysis (GFRA) in order to obtain maximum Material Removal Rate (MRR) with minimum Radial Over Cut (ROC). The experimental study has shown that ROC has been reduced to greater extend with improvement in material removal through optimisation of process parameters using GFRA. From the GFRA analysis, at an optimised parameters combination, a higher MRR of 0.075 mg/min with minimum ROC 0.01 mm is obtained for borosilicate glass workpiece.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
