Abstract
Two running-in processes, i.e., polishing a diamond-like carbon (DLC) coated disk and pre-sliding in ambient air, were suggested as a delamination suppression method for self-mating DLC coatings in water, and the effects of these methods were verified using a ball-on-disk tribometer. An a-C:H-type DLC coating was deposited on SUJ2 bearing steel balls and disks using plasma chemical vapor deposition. It was confirmed that delamination of DLC coatings was suppressed because microcracks were not generated by removing droplets on the DLC coated disk using the polishing process. The friction coefficient in that condition was reduced to about one-fifth of that of the untreated disk. The running-in process of pre-sliding in ambient air also suppressed delamination of DLC coatings. Moreover, the friction coefficient after this process was reduced to half of that with the other polishing process in the boundary lubrication condition. It was found that these effects have a relationship with surface smoothness and hydrophilicity.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.