Effect of rotating magnetic field on the microstructure and properties of Sn-Ag-Sb lead-free solder alloys

Abstract

PurposeThe purpose of this paper is to study the microstructure and properties of Sn-3.5Ag and Sn-3.5Ag-0.5Sb lead-free solder alloys with and without a rotating magnetic field (RMF).Design/methodology/approachOptical microscopy, scanning electron microscopy and X-ray diffraction were used to analyze the effect of an RMF on the microstructure of the solders. Differential scanning calorimetry was used to study the influence of the RMF on the thermal characteristics of the solders. The mechanical properties of the alloys were determined by tensile measurements at different strain rates.FindingsThe ß-Sn grains and intermetallic compounds for the Sn-3.5Ag and Sn-3.5Ag-0.5Sb lead-free solder alloys were refined under an RMF, and the morphology of the ß-Sn grains changed from dendritic to equiaxed. The pasty range was significantly reduced under an RMF. The ultimate tensile strength (UTS) of Sn-3.5Ag improved under the RMF, whereas the UTS of Sn-3.5Ag-0.5Sb decreased slightly. The addition of Sb to the Sn-3.5Ag alloy significantly enhanced the UTS and elongation (El.%) of the samples. The UTS of the solder increased with increasing strain rate.Originality/valueThe results revealed that the application of RMF in the molten alloy had a significant effect on its microstructure and mechanical properties. The thermal characteristics of the Sn-3.5Ag and Sn-3.5Ag-0.5Sb solder alloys were improved under the RMF. This research is expected to fill a knowledge gap regarding the behaviour of Sn-Ag solder alloys under RMF.