Abstract
Chemical demulsification is widely used in the petroleum industry to remove water from crude oil all over the world. In this work, the relationship between the rheological properties of oil/water interfacial film and demulsification of crude oil emulsions was investigated. The results showed that the elastic modulus was the critical factor for the dehydration ratio, the emulsions showed high dehydration ratio when demulsifiers reduced the elastic modulus of oil–water film to a certain extent (below 5 mN/m). Correlations between dehydration ratio and equilibrium interfacial tension, dynamic interfacial tension, and loss modulus were also investigated. The results showed no correlation between the interfacial tension (IFT), the loss modulus, and the dehydration ratio. However, correlations were observed between dynamic IFT, loss modulus, and demulsification speed when the demulsifier could reduce the elastic modulus of the oil–water film to <5 mN/m. The loss modulus was directly proportional to the surface ...
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.