Effect of resin cements and aging on cuspal deflection and fracture resistance of teeth restored with composite resin inlays.

Abstract

To evaluate the influence of resin cements and aging on cuspal deflection, fracture resistance, and mode of failure of endodontically treated teeth restored with composite resin inlays. Seventy-two maxillary premolars were divided into 6 groups: 1: sound teeth as control (C); 2: preparations without restoration (WR); 3: inlays luted with RelyX ARC (ARC); 4: inlays luted with RelyX Unicem (RLXU); 5: inlays luted with Maxcem Elite (MCE); 6: inlays luted with SeT (ST). Groups 2 to 6 received mesio-occlusal-distal preparations and endodontic treatment. Stone casts were made for groups 3 to 6. Composite resin inlays were built over each cast and luted with the resin cements. A 200-N load was applied on the occlusal aspect and the cuspal deflection was measured using a micrometer before and after 500,000 cycles of fatigue loading (200 N; 500,000 cycles). The specimens were then submitted to an axial load until failure. The median cuspal deflection (µm) and median fracture resistance (N) were calculated and statistically analyzed using Kruskal-Wallis and Mann-Whitney tests (p < 0.01). Values followed by the same letter represent no statistically significant difference. Cuspal deflection before cyclic loading: C = 3 µma; ARC = 4 µmab; RLXU= 5 µmab; MCE = 21 µmb; ST = 51 µmbc; WR = 69 µmc. Cuspal deflection after cyclic loading: ARC = 6 µma; RLXU = 19 µmab; MCE = 33 µmb; ST = 62 µmb. Fracture resistance in N: C = 1902a; ARC = 980b; RLXU = 670c; MCE = 533c; ST = 601c; WR = 526c. According to the Wilcoxon test, there was no statistical difference between the cuspal deflection before and after cyclic loading only for ARC (p = 0.015). There was a predominance of recovery fractures for the restored groups. Composite resin inlays luted with RelyX ARC maintained cuspal deflection stability and showed higher fracture resistance of the teeth than did inlays luted with the other cements tested.