Effect of residual volume after surgery of the discoid lateral meniscus on tibiofemoral joint biomechanics: a finite element analysis

Abstract

BackgroundThe purpose of this study was to investigate the influence of different residual meniscus volume on the biomechanics of tibiofemoral joint after discoid lateral meniscus (DLM) surgery by finite element analysis.MethodsA knee joint model was established based on CT and MRI imaging data. The DLM model was divided into five regions according to conventional meniscectomy, with volumes of 15%, 15%, 15%, 15%, 15%, and 40% for each region. Additionally, the DLM model was divided into anterior and posterior parts to obtain ten regions. The DLM was resected according to the design scheme, and together with the intact discoid meniscus, a total of 15 models were obtained. Finite element analysis was conducted to assess shear and pressure trends on the knee joint.ResultsThe study observed significant changes in peak shear stress and compressive stress in the lateral meniscus and lateral femur cartilage. As the meniscus volume decreased, there was an increase in these stresses. Specifically, when the meniscus volume reduced to 40%, there was a sharp increase in shear stress (302%) and compressive stress (152%) on the meniscus, as well as shear stress (195%) and compressive stress (157%) on the lateral femur cartilage. Furthermore, the model grouping results showed that preserving a higher frontal volume in the meniscus model provided better biomechanical advantages.ConclusionThe use of finite element analysis has demonstrated that preserving more than 55% of the meniscus volume is necessary to prevent a significant increase in joint stress, which can potentially lead to joint degeneration. Additionally, it is crucial to preserve the front volume of the DLM in order to achieve improved knee biomechanical outcomes.