Abstract
The effect of repeated UV-irradiation on mechanical and biochemical parameters was studied in skin of hairless mice. UV-A irradiation for a period of 1 h daily over 8 weeks caused only a slight increase in skin thickness and a decrease in ultimate strain. The changes induced by UV-B and C, however, were quite remarkable. Skin thickness was increased depending on the daily dose exposure time (15--90 s at an irradiation rate of 20 mW/cm2 UV-B and A and of 14 mW/cm2 UV-C) and the duration of treatment (1--6 weeks). Ultimate load, tensile strength and modulus of elasticity showed an increase following medium dosages after 1 and 2 weeks, however, a decrease after high dosages and longterm treatment. Ultimate strain was found to be the most sensitive parameter being decreased depending on exposure time and duration of treatment. Insoluble collagen and total collagen were decreased after long-term treatment thus being correlated with the mechanical parameters. The elastin content was only barely influenced and not correlated with the mechanical data, e.g. the modulus of elasticity. Thus, a favourable effect of short-term treatment with low doses of UV-irradiation of mechanical parameters of skin could be demonstrated. Long-term treatment with relatively high doses of UV-B, however, resulted in unfavourable effects, whereby first ultimate strain, then ultimate load, modulus of elasticity and tensile strength were decreased.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.