Effect of Refractance Window™ and oven drying on physicochemical and sensory properties of peach (Prunus persica L.) surplus.

Abstract

Currently, approximately 34% of fruit is lost and wasted in emerging economies due to inefficient post-harvest processes, technological shortcomings, lesser valorization of surpluses, and byproducts. Peach (Prunus persica L.) is a fruit with a good yearly growth rate but higher postharvest losses in Colombia. One way to take advantage of this type of product is through the application of drying processes that increase its shelf life and its inclusion in the food chain. Refractance Window Drying (RWD) is a fourth generation drying technique implemented by the food industry in the last few decades and has been applied to several dehydrated food products. This study compared the effects of different drying methods on the physical and sensory properties of peaches surplus. Treatments consisted of (i) peaches were sliced (1, 2, and 3 mm thickness) and dried using RWD at 86°C, (ii) peach pulp mixed with maltodextrin (MD) (0.12-0.33 kg of MD/kg of sample) and RWD (RWD-MD), and (iii) conventional oven drying (OD) at 60°C (3 mm thick) dried for 24 h. The study found that the drying method significantly (p < 0.05) affected the texture, color, and general taste of peaches. The results showed that processing treatments combined with different drying conditions affected the physical properties of the peach. RWD in slices reduced water content to 0.05 kg H2O/kg in 40 min, showing fewer effects on color attributes. A surface response analysis on RWD showed good correlations for water activity (R2 = 0.8652-0.9894) and moisture content (R2 = 0.7048-0.9826). A higher diffusion coefficient (1.63 × 10-6 m2 s-1) was observed for RWD in slices with 3 × 10-3 m of thickness; however, for RWD-MD, differences in diffusion coefficients were present for the lowest MD addition (0.12 kg/kg), vitamin C was not detected on the dried slices, and higher concentration of β-carotene (175.88 μg/100 g) was found on the thinner slices. Principal component analysis showed that RWD in the slices was the most suitable drying process, followed by OD. Sensory analysis showed good acceptability for RWD slices after 30 days of storage.