Abstract
We have studied the influence of radio frequency (RF) power on material properties of hydrogenated amorphous carbon (a-C:H) films prepared by RF plasma-enhanced chemical vapor deposition (CVD). The RF power has a significant impact on film properties such as electron spin resonance (ESR) spin density, the optical band gap, chemical bonding and photoluminescence (PL). Raman spectroscopy, infrared (IR) absorption and ESR measurements reveal that the residual defect density (ESR spin density) increases with increasing RF power due to the increase of sp2 C–Hx components. We obtained an ESR spin density as small as 8 ×1016 spins/cm3 at a low RF power, which is comparable to that of high-quality amorphous silicon films. Plasma optical emission spectroscopy indicates that the intensity ratio (IC–H/IH) between hydrogen peaks (IH) and hydrocarbon peaks (IC–H) significantly decreases with increasing RF power. The optical band gap, obtained from UV-visible spectroscopy, varies from 3.0 to 1.9 eV with increasing RF power. The broad emission band centered around 2.4 eV was observed in the PL spectra of the samples deposited at lower RF powers. We found a 0.5–0.3 eV Stokes shift by comparing the PL emission and the absorption coefficient spectrum from the films deposited at ≤100 W RF powers, whereas, we failed to observe a clear Stokes shift from the films deposited at >100 W RF powers. A weak correlation between the PL peak and the optical band gap is demonstrated.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.