Abstract
Some gears in an automobile transmission have to be mounted by being press-fitted on a shaft instead of splines. The torque capacity of the press-fitted gear will be proportional to the radial interference. The excessive interference, however, will increase the gear radial deformation. In this paper, the press- and shrink-fit and the subsequent torque capacity test were investigated by finite element analysis, theoretically and experimentally. The static and dynamic coefficient of friction were determined.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.