Effect of prosthetic design and restorative material on the stress distribution of implant-supported 3-unit fixed partial dentures: 3D-FEA

Abstract

Objective: Evaluate the effect of Implant prosthetic designs and restorative material on the stress concentrationof 3-unit implant-supported restoration with two restorative materials. Material and Methods: Six differentscrew-retained prostheses models were virtually designed and divided according to design: fixed bridge (FB),cantilever bridge (CB), and separate crowns (SC). Then, each model was also divided into two subgroupsaccording to the material: Ultra-translucent multi-layered zirconia (Kuraray Noritake Dental Inc., Japan); or acombination of PEEK (Polyetheretherketone) framework (BioHPP, Bredent, GmbH & Co., KG, Germany) andzirconia (ZR) crowns (ultra-translucent multi-layered zirconia, Kuraray Noritake Dental Inc., Japan). A verticalload of 100 N was applied statically perpendicular to the central fossa of each crown. The von-Mises stress wascomputed using Solidworks software (SolidWorks Corp, Massachusetts, USA), based on the physical parametersof the materials. Results: FB showed the lowest von Mises stress values out of all 3 design models. Moreover,the combination of PEEK and zirconia showed strain values smaller than full zirconia. The highest von Misesstress value was recorded in CB with the zirconia subgroup at (1098 MPa) while the lowest von Mises stressvalue was recorded in FB with combined PEEK and zirconia subgroup at (190 MPa). Conclusion: For three-unitimplant supported restorations, the use of PEEK framework and zirconia crowns was found to be more favorablebiomechanically regarding the prosthetic components, implant and bone stresses. KEYWORDSBiomechanics; Dental implants; Implant prosthetic designs; Finite element analysis; CAD/CAM.