Effect of processing parameters and carbon to metal ratio on microstructure and mechanical properties of (MoTaTiVW)Cx high entropy carbide produced by reactive spark plasma sintering

Abstract

(MoTaTiVW)Cx high entropy ceramics with varying carbon to metal ratio in the range of 0.75-0.97 were synthesized by by reactive spark plasma sintering. The effect of ball milling time on particle size, phase evolution and carbon pick-up due to toluene decomposition were studied. Formation of single-phase high entropy carbide having face-centered cubic (FCC) crystal structure was confirmed by X-ray diffraction (XRD), electron backscattered diffraction (EBSD) and Selected area diffraction pattern (SAED) analysis of the sintered compacts. Transmission Kikuchi Diffraction images revealed presence of equiaxed nature of the grains. Transmission electron microscopy images revealed the presence of an intergranular phase at grain boundaries and triple junctions. 3D-Atom Probe Tomography studies showed uniform distribution of elements within the grains with some segregation of impurity elements Fe and Co to the grain boundaries indicating minor contribution of liquid phase sintering to densification. The grain size of single-phase sintered compacts ranged between 1.69 ± 0.60 μm to 4.6 ± 1.0 μm. A low sintering temperature and higher milling time resulted in finer grain size The microhardness was found to increase with milling time and C/M ratio. The microhardness, Young’s modulus and indentation fracture toughness lied between 2221 HV0.1 to 2732 HV0.1, 370 GPa to 473 GPa, 3.6 MPa.m1/2 to 4.4 MPa.m1/2, respectively. The highest microhardness and indentation fracture toughness was found to be 2732 ± 80 HV0.1 and 4.4 MPa.m1/2 on par with reported literature for other high entropy carbides.