Abstract
The relationships between the inertia friction welding process parameters (initial angular velocity, ωₒ, and moment of inertia, I, of the flywheel and the axial compression force, P) and welding behavior (welding time, sample upset and flash formation, efficiency and kinetics of friction-induced sample heating) of dissimilar superalloys were determined. The results showed that the initial kinetic energy of the flywheel, Eo=Iωₒ2/2, should not be considered as a key parameter for the design of the IFW process. Only a fraction of this energy (denoted as ‘sample energy’, ES), which is process-parameters dependent, is used to heat the workpieces at the weld interface. Together with I and P, ES controls the upset length, the duration of the welding process, temperature profiles near the weld interface and the weld quality. Optimization of the inertia friction welding for better quality, reduced energy consumption and materials saving requires information about the process efficiency η=ES/Eo and its dependence on the process parameters. Critical sample energy per unit surface area (≈79MJ/m2) was identified above which good quality metallurgical bonds were produced between LSHR and Mar-M247 alloys.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
