Effect of pressure on structure and properties of lyocell fabric-based all-cellulose composite laminates

Abstract

In this work, all-cellulose composite (ACC) laminates were manufactured from lyocell fabric using a simple hand lay-up and compression molding-based surface-selective dissolution technique. In dissolution step, temperature and dissolution time were fixed and pressure varied. Subsequently, the dissolved cellulose was regenerated via solvent exchange and then dried by hot-pressing. The microstructures of ACC laminates were analyzed by scanning electron microscope micrographs and measuring void content. Optimum microstructure and mechanical properties were obtained with a pressure of 1 MPa, but slightly deteriorated with further increase in pressure. The highest tensile strength and modulus achieved were 44.24 ± 2.2 MPa and 1.78 ± 0.14 GPa, respectively, for ACC-3. Best flexural strength and modulus obtained were 48.95 ± 2.87 MPa and 0.96 ± 0.21 GPa, respectively, for the same sample. The T-peel strength of ACC-3 also was very high, 2.78 ± 0.34 MPa. Application of pressure during drying had a great role on controlling shrinkage and internal voids in ACC laminates.