Effect of Preheat Temperature and Welding Sequence on the Temperature Distribution and Residual Stress in the Weld Overlay Repair of Hydroturbine Runner.

Abstract

The hydroturbine runner is the core of the whole hydroelectric generating unit, which is employed to transform water energy into mechanical energy. In the process of service, the runner frequently suffers from abrasion due to erosion and cavitation. Defects are usually repaired by welding. To acquire suitable weld cladding repair process parameters, a combination of experimental and numerical simulation was applied to investigate the temperature and weld residual stress distribution in the repair zone under the different welding repair approaches. The results illustrate that the temperature and welding residual stress distribution of the blade and the shroud are out of symmetry, the temperature conduction rate is faster on the blade side, and the high-stress zone is predominantly concentrated in the weld and its adjacent area. When the preheating temperature is up to 150 °C, the peak value of welding residual stress reaches a minimum of 796.29 MPa. The welding sequence can adjust the distribution trend of welding residual stresses. The welding sequence of three-stage welding can effectively reduce the welding residual stresses near the shroud at the water outlet side of the blade. The results of the study will provide theoretical guidance for the welding repair of hydraulic turbine runners.