Abstract
ABSTRACT Low-pressure powder injection moulding (LPIM) is a cost-effective manufacturing technology used to fabricate complex-shaped parts with high mechanical properties at low- or high-volume production. This research work presents an experimental approach to investigate the debound/sintered properties of iron components produced by the LPIM process using iron-based powders exhibiting different particle shapes and size distributions. Four low-viscosity feedstocks were mixed and injected into a rectangular mould cavity before being thermally wick-debound and finally sintered using identical debinding and sintering cycles. This study confirms that both irregular and spherical iron powders can be shaped via the LPIM process. The solid loadings obtained with these two powder morphologies, varying from 58 to 62 vol.-%, represent expected values. The trend in the density values obtained with irregular (∼6.6 g/cm3) and spherical (∼7.5 g/cm3) powders was validated by metallographic observations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
