Abstract
This paper presents the experimental investigation conducted on Al-Si cast alloy (LM6) cast using lost foam process. The main objective of the research is to investigate the effect of pouring temperature, section thickness and melt treatment on the microstructure of the lost foam casting of Al-Si alloy. Step pattern with five different sections was prepared from 20 kg/m³ density foam and poured at five different temperatures; 700, 720, 740, 760, and 780 with and without the addition of AlTiB as grain refiner. Analysis on microstructure, eutectic silicon spacing and porosity percentage were conducted to determine the effect of both parameters. The results show that pouring temperature has significant influence on the quality as well as microstructure of the lost foam casting of LM6 Al-Si alloy. Lower pouring temperature was found to produce finer microstructure casting. However, the addition of AlTiB as grain refiner did not affect the produced castings significantly whether in terms casting quality or microstructure.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
