Abstract
This article presents the results of research on the development of the technology of laser beam butt welding of 17-4 PH stainless steel sheets and the technology of post-weld heat treatment (PWHT). The developed technology allows for favorable conditions to be obtained and for the appropriate microstructure and hardness to exist in the weld area. Moreover, it enables the fulfillment of a number of specific requirements beyond the possibilities of manual welding and other methods. The tests performed include the analysis of the microstructure with the use of light microscopy (LM) for the materials after welding and PWHT. The applied PWHT showed changes in the microstructure and mechanical properties. In all weld areas the martensitic microstructure was observed. The homogeneity of the microstructure in the area of the welded joint after PWTH was revealed. In the as-welded condition and after the PWHT with aging at 481 °C, the hardness was 440 HV5, but after aging at 621 °C, it decreased to 330-340 HV5.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
