Effect of Pole Shaping on Torque Characteristics of Consequent Pole PM Machines

Abstract

Consequent pole (CP) permanent magnet (PM) machines offer scope for reducing the quantity of PM material and hence cost compared to more conventional PM machine topologies of the same rating. In this type of machine, the rotor pole arc is usually optimized to realize the largest output torque with pole shaping methods used to reduce torque ripple. However, such approaches tend to be limited by constraints imposed on the pole shapes. It is a common practice to adopt similar PM and iron pole shapes, an approach that does not fully account for the different characteristics of PM and iron poles in CPPM machines, often leading to large even order harmonics in the airgap flux density. This article proposes a shaping method with a variable rotor profile and pole arc span being established by means of optimization by Genetic Algorithm. It is demonstrated that for a fixed quantity of PM material, different PM and iron pole shapes in combination with optimal PM and iron pole arc spans are essential for ensuring both maximum output torque and lower torque ripple when the due account is taken of flux leakage. It also demonstrates that since the flux density in the region under a PM pole is governed by the magnetic potential produced by magnets while it is governed by magnetic reluctance under iron pole, different PM pole and iron pole shapes are necessary to reduce the even-order harmonics in a CPPM machine and consequently to reduce torque ripple. The performances of optimized and more conventional CP machines are compared by finite-element method on 12-slot/8-pole prototype motors.