Abstract
Abstract Drilling of composites are generally associated with fiber pull out and delamination. The aim of this paper is to optimize the drilling process parameters and study the influence of twist drill bit geometry like point angle on delamination by FE analysis and experimental studies. Using DOE technique, different speeds and feed rates are used to carry out drilling of CFRP laminates experimentally and by ABAQUS. Delamination area of CFRP drilled hole from simulation and experimental results are analysed using Image J software. Speed of 3500 rpm and a feed rate of 0.1 mm/rev is found to be optimum value. Further, point angle in drill bit geometry is modified to 900, 1180 and 1350 and effect of delamination is simulated and studied using ABAQUS.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
