Effect of plasma surface treatment and heat treatment ambience on mechanical and corrosion protection properties of hybrid sol–gel coatings on aluminum

Abstract

Hybrid sol–gel coatings derived from a base catalyzed hydrolysis of tetraethylorthosilicate and methyltriethoxysilane were deposited on aluminum substrates by a dip coating technique. Some of the coatings were deposited on substrates whose surfaces were pre-treated using atmospheric-air plasma prior to coating in order to study the effect of surface activation by plasma pre-treatment. The coated substrates were heat treated in different ambiences like air, flowing N 2 and vacuum to see the effect of heat treatment ambience on the properties of the coatings. Characterization of the coatings after heat treatment was carried out with respect to coating thickness, pencil scratch hardness, adhesion, water contact angle and their microstructure. Corrosion testing for all the coatings was carried out by electrochemical polarization measurements as well as electrochemical impedance spectroscopy in 3.5% NaCl solution for 1 h exposure time to investigate on their corrosion resistance. Coating thicknesses ranging from 1 μm–5 μm were obtained by varying the withdrawal speeds. Heat treatment in a controlled atmosphere with low oxygen content was seen to improve the hydrophobicity of coated surface, as measured by water contact angles (20 o — air; 71 o — N 2; 95 o — vacuum), thereby improving the corrosion resistance. Surface pre-treatment using open-air plasma was seen to improve the adhesion of the sol–gel coatings thus making it possible to obtain adherent and thick coatings in a single dip coating process. Both the methods of processing the coatings reduced the corrosion rate of aluminum from 1.95 mpy to 0.004 mpy in case of coatings densified in nitrogen and to 0.00068 mpy for coatings deposited on a plasma treated substrate and densified in air.