Abstract
Abstract Ni-P coated diamond (NPCD) with different phosphorus content was prepared by electroless plating through adjusting NaH 2 PO 2 concentration in plating bath. Effect of phosphorus content on the properties of NPCD as surface microstructure, phase structure and heat resistance was studied and compared with that of diamond with no Ni-P coatings. The surface microstructure and the chemical composition were determined by environmental scanning electron microscope (ESEM). The phase structure was observed by X-ray diffraction (XRD). The results demonstrated that a lower phosphorus content of NPCD corresponds to better surface properties with lower roughness and higher heat resistance. A higher phosphorus content, on the contrary, leads to worse overall performance of Ni-P coating.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
