Abstract
Fe–Ni heterogeneous alloys were prepared from powders by pressing, sintering, hot rolling, cold rolling, and heat treatment. A composite alloy was produced which consisted of ferrite, martensite, and austenite phases elongated parallel to the rolling direction. The volume fraction of each phase depended on the amount of Ni powder and the annealing temperature. The strength and elongation of the alloy increased with the amount of martensite phase and austenite phase, respectively. Both its yield strength and uniform elongation satisfied a rule of mixtures qualitatively. It was found that inhomogeneous Ni distribution affected the formation of each phase and the mechanical properties of the alloys.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.