Abstract
This paper presents the results of a laboratory study on the effect of pH (2, 5, and 9) and gas-phase ozone concentration (1, 7, and 11 wt %) on the decolorization efficiency via ozonation for seven common textile dyes. Higher gas-phase ozone concentrations resulted in higher decolorization rates due to more rapid ozone transfer. Higher gas-phase ozone concentration, however, was also observed to have a positive, neutral, or negative effect on ozone dose requirements for different dyes. In general, greater ozone utilization efficiency was achieved at lower pH levels where direct ozone reactions predominate. It was observed that because ozonation can cause significant resolubilization of precipitated dyes, complete removal of dye precipitate should be accomplished prior to polishing via ozonation. The results point to the need for laboratory and/or pilot testing for dye-laden wastestreams to allow process optimization.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
