Effect of particle volume fraction on wear behavior in Al–SiC MMC coated on DIN AlZnMgCu1.5 alloy

Abstract

Abstract In this study, DIN AlZnMgCu1.5 alloy surface (Al + SiC) was coated with metal matrix composite (MMC) by using hot press sintering method (HPSM). Al was used as matrix material and SiC powders were used as reinforcing material in the coating process on DIN AlZnMgCu1.5 alloy surface. Al/SiC MMC coating was produced at 600 °C under 120 MPa pressure and with varying SiC content (5, 10 and 15 vol.%). Optical microscopy (OM), scanning electron microscopy (SEM), energy dispersive X-ray spectroscopy (EDS), and X-ray diffraction (XRD) were used to examine the microstructure, elemental analysis and phase structure of both the coating zone and the transition zone between the substrate and the coating. The hardness was measured and a dry sliding linear reciprocating wear test was run to determine the mechanical properties of the coating layer. Consequently, the coefficient of friction (COF) and wear volume were determined. OM and SEM images showed a homogeneous distribution of SiC particles and a less porous structure. The hardness of the MMC coating increased with increasing SiC content. Also, the numerical analysis of the wear test simulation was done based on Archard’s law. The results of both wear tests showed that the volume loss values were consistent with each other and the amount of wear significantly reduced by increasing the rate of SiC reinforcement.