Abstract
In this study, shape characteristics of talc particles produced by ball, rod and autogenous mills were investigated using Scanning Electron Microscope (SEM) and expressed by the shape descriptors such as elongation, flatness, roundness and relative width by measuring on the particle projections in two dimensions (2D). Approximately, 139 particles were measured for image analysis from each mill product. Surface roughness values of talc mineral have been expressed by the parameters of R a value on the pelleted surfaces of the particles by employing Surtronic 3 + instrument. The wettability characteristics ( γ c) of talc mineral, produced by three different mills, were also determined by microflotation and the contact angle measurement techniques using the EMDEE MicroFLOT cell and Rame-Hart goniometer, respectively. Some correlations were established between the shape properties, surface roughness values and the wettability characteristics. The results have shown that elongation and smoothness helped to increase the hydrophobicity, while roundness and roughness caused a decrease in hydrophobicity or floatability for the talc mineral studied.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.