Effect of oscillation flow induced by lattices on a horizontal gas–solid two-phase flow

Abstract

This study is focused on reducing the pressure drop, conveying velocity, and power consumption in a horizontal gas–solid flow. Four types of lattice models, which are fixed in the particle inlet, are proposed to easily generate the oscillation of the wake flow to easily convey the gas–solid two-phase flow. A horizontal pipeline with an inner diameter of 80 mm and length of approximately 5 m was used. Polyethylene particles with an average diameter of 2.3 mm and density of 978 kg/m3 were employed as conveying solid materials. The experimental ranges of the average gas velocity and solid mass flow rate were 10–16 m/s and 0.10–0.47 kg/s, respectively. Compared to the nonlattice gas–solid flow, reductions in the total pressure drop, conveying gas velocity, power consumption, and additional pressure loss were achieved in the range of lower gas velocity when using the lattice model. The highest reduction rates of the minimum conveying velocity and additional pressure drop were approximately 5.12% and 15.2%, respectively. In the acceleration region, the particle concentration in the flows with the lattice model was larger than that in the nonlattice flow near the upper part of the pipe and lower than those in the nonlattice flows in the lower part of the pipe. The time-mean axial particle velocity and particle fluctuating velocity in all lattice model flows were higher than those in the nonlattice flow, according to particle image velocimetry measurements, particularly in the upper part of the pipe.