Effect of orientation of stirrups in combination with shear span to depth ratio on shear capacity of RC beams

Abstract

The shear behavior of reinforced concrete (RC) beams has been a major research area for a long time. Since the shear response of RC beams is affected by different factors, many researchers have reported that the nature of shear behavior is complicated. One of these factors worth investigating is the inclination of shear reinforcements. This paper investigated the effect of the orientation of stirrups on the shear capacity of RC beams as the shear-span-to-depth ratio (a/d) varies. The contribution of concrete compressive strength was also studied. An experimental program investigating 21 RC beams has been conducted. The test results revealed that the shear capacity increases as the arrangement of stirrup changes from conventional vertical arrangement to inclined arrangement. However, the increment is high in beams with (a/d) ratio of 2.2 than beams with (a/d) ratio of 2.6, which are relatively slender. Shear capacity also increases as concrete compressive strength increase, which shows that concrete contribution to the shear capacity of beams should be taken in to account.In addition to the experimental test, the beams were analyzed numerically by using a general-purpose finite element package, Abaqus. The shear capacity of reinforced concrete beams obtained from the numerical analysis is in a good agreement with the experimental result. The results obtained by numerical analysis and experimental tests are compared to analytically calculated values by using shear provisions of ACI 318-14 and EN-2. Both ACI 318-14 and EN-2 are generally conservative in predicting the shear capacity of RC beams. However, the conservativeness of these codes reduced as a/d ratio of the beams increase.