Effect of orientation and nanoparticle addition of a encapsulated phase change material on heat transfer in a packed bed thermal energy storage system – A numerical analysis

Abstract

Thermal energy storage technology research is growing globally due to the increased awareness of the clean energy demand and limitations of fossil fuel commodities. The packed bed latent heat thermal energy storage (PBLHTES) system is one among it promising a greater number of applications like solar water heating, industrial waste heat recovery process, thermal power generations, thermal comfort of buildings etc., Due to the high latent heat capacities, available in wide temperature ranges and minimal volume change, solid-to-liquid phase change materials (PCMs) are more attractive than any other latent heat materials to use in the PBLHTES system. Although, the low conductivity of PCM restricts the heat transfer while the charging and discharging periods. Therefore, it is necessary to incorporate thermal enhancement techniques in a PBLHTES system to improve the melting rate of the PCM. In this work, it is attempted to carry the 2-D numerical analysis of PBLHTES system provided with encapsulated PCM staggered in the flow direction of heat transfer fluid. The numerical results are validated with the experimental work. The effect of the inclination of PCM capsules with the flow direction (0°, 2.5°, 5°, 7.5°, and 10°), the addition of Multi-walled carbon nanotubes (MWCNT) nanoparticles (0 %, 1 %, 2 %, 3 %, 4 %, and 5 %) on energy absorbed by the PCM are studied. Also, the contours of temperature distribution and liquid fraction of the PCM with time are presented. The results revealed that the temperature distribution of HTF rises when PCM spheres orientated to the HTF shifted from 0 to 2.5° later it reduces. Though HTF temperature rises, the PCM temperature, liquid Fraction and energy absorbed decline when the capsules inclined to the flow direction. This is mainly due to the reason that the HTF moves outwards from the flow direction and towards the edges of the container, which makes the HTF carry a more amount of heat without sharing with the PCM capsules. Therefore, these arrangements will be helpful to switch over the ideal high-temperature HTF at the outlet without charging the TES system and vice versa. An improvement of 13.16 % melting rate is observed from 0 to 3 % of a nanoparticle addition and only 4 % enhancement is noted from 3 to 5 % MWCNT deposition. The effect of nanoparticles on energy absorbed by the PCM is nearly constant after 3 % of Multi-walled carbon nanotubes (MWCNT) addition. Therefore, this is the optimum MWCNT volume concentration to be added. The maximum energy absorbed with 3 % MWCNT for 60 min of time is 98.7 kJ and 97 kJ which are 3.5 % and 3.65 % more than the pure PCM for the standard case (0°) and 2.5° angle of attack of EPCMs with the flow direction.