Abstract
Introduction: In this study, the effect of different weighing material such as olivine, barite and calcium carbonate on cutting carrying of water-based drilling fluids was investigated. Initially, characterization studies were performed for the additive materials. Method: Then, spud type muds were prepared with bentonite and the weighing materials were added at different rates ranging from wt.1-6%. After the sample preparation, mud weight, 600 and 300 rpm dial reading, plastic viscosity, yield point, flow behavior index and power law consistency factor values were measured/calculated. Result: With these results, cutting carrying index of the muds was calculated and the effect of the additive materials was compared. According to the results, it was determined that the barite added muds had better cutting carrying capacity than others and the calcium carbonate added muds showed worse cutting carrying capacity. Optimal CCI results were obtained from O-5 as 3.7869 and, from B-6 as 5.9417 and from C-4 as 2.7113. Conclusion: Results of this study show that olivine can be used as low additive ratios in drilling muds to clean the hole.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
