Abstract
AbstractFused deposition modeling (FDM) is a material extrusion technique that works by extruding molten filament on a heated platform. In this method, several manufacturing parameters are engaged which affect the mechanical performance of printed parts. In this study, the effects of nozzle diameter on tensile (under two loading rates) and mixed‐mode I/II fracture behavior of printed specimens were examined. The obtained results revealed that testing speed had a minor effect on basic mechanical properties. For instance, ultimate tensile strengths of tensile specimens printed with 1 mm nozzle diameter were 32.56 and 39.71 MPa for test speeds of 1 and 5 mm/min, respectively. Higher nozzle diameters resulted in higher mechanical properties and fracture resistance (e.g., specimens printed with 45/−45° raster angle with 0.4 and 1 mm nozzle diameters indicated fracture loads of 4520 and 5071 N, respectively). Besides, fracture loads were predicted through the equivalent material concept coupled with J‐integral method.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Fatigue & Fracture of Engineering Materials & Structures
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
