Abstract
In this paper, the effect of non-uniform heating on the conjugate thermal and hydraulic characteristics for Al2O3–water nanofluid flow through a converging duct is examined numerically. An Eulerian–Lagrangian model is employed to simulate the two-phase flow for the following range of parameters: Reynolds number (100 ≤ Re ≤ 800), nanoparticle volume fraction (0% ≤ ϕ ≤ 5%) and amplitude of the sinusoidal heat flux ( A = 0, 0.5 and 1). The results reveal a similar affinity between the applied heat flux and local Nusselt number variation qualitatively, mainly at the middle of the duct. The results also indicate that there is a considerable enhancement of Nusselt number with the increase in Reynolds number and the thermal conductivity of wall materials. In addition, increasing the particle loading contributes to an enhanced rate of heat transfer. The heat transfer rate is lower for non-uniform heating when compared with the constant heat flux and the same can be compensated by the application of volume fraction of nanoparticles
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
