Abstract

In this paper, the physical and mechanical properties of TISCO steel slag were tested by composite activators with different ratios. The optimal neutral composite activator was determined, and the properties of neutral activated steel slag power-cement composite cementitious material with 30% cement content were studied. The experimental results indicated that the best ratio of gypsum: silica fume: sodium sulfate: sodium aluminate: self-made activator was 2.5:2.5:1:0.5. By XRD, SEM and TG-DTG detection, it was found that the less stable periclase reduced in 30% cement content and activated steel slag slurry. After 28d curing, the micro morphology and compactness of hydration products were not different from that of cement, even no incompletely hydrated particles. The voids between hydration products and the interface of different hydration products were continuously filled with hydration products over age. C-S-H and AFt generated by 7d activated SSP cement composite powder was greater than that of cement. At 28d, a small amount of Ca(OH)2 was generated. The results show that the combination of self-made neutral activator and other activators can improve the properties of cement steel slag powder composite cementitious material and improve the utilization rate of steel slag.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.