Abstract
The observation on microstructure and microhardness has been evaluated by experimental methods and also approached to simulation work. One found out higher volume fraction of martensite inside the HAZ and the FZ that is the main cause of higher hardness insides these zones and no softening zone created by laser Nd: YAG on sheet metal of dual phase steel DP600. So the precaution during laser welding Nd: YAG at any welding speed, focal point position and power should be considered in order to prevent a crack and fracture of laser lap joint DP600 during service.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
