Effect of nAl2O3 on the part density and microstructure during the laser-based powder bed fusion of AlSi10Mg composite

Abstract

PurposeIn recent years, additive manufacturing techniques have attracted much research attention because of their ability to fabricate customised parts with complex geometry. The range of composites suitable for laser-based powder bed fusion technique is limited, and has not been investigated yet. This paper aims to study the fabrication of AlSi10Mg reinforced with nAl2O3 using the laser-based powder bed fusion technique.Design/methodology/approachAn experimental approach was used to investigate the densification of AlSi10Mg–nAl2O3 composites using laser-based powder bed fusion technique. Optimisation of the porosity was performed, and microstructure evolution was evaluated.FindingsIn this study, laser volumetric energy density (approximately 109 J/mm3) was found to be required for the fabrication of AlSi10Mg–nAl2O3 composites with a relative volumetric density approximating 99%. The use of laser volumetric energy density resulted in larger grains. Columnar grain structure was observed via the use of electron backscatter diffraction mapping.Originality/valueThis paper examines the processing of new aluminium composite material suitable for the fabrication via the laser-based powder bed fusion technique.