Abstract
Adding plasticizer is an appealing strategy to optimize binder removal for ceramic components fabricated by vat photopolymerization (VPP). However, so far the studies for effect mechanism of plasticizer on whole technological process of VPP are comparatively very limited, especially through analysis of physical and chemical properties of plasticizers. Herein, the effect of molecular weight and chemical structure of plasticizer on suspension property, binder removal, and sintered performance of zirconia toughened alumina (ZTA) ceramics was comprehensively investigated. Two types of plasticizers, namely, polyethylene glycol (PEG) and polypropylene glycol (PPG), with various molecular weights from 200 to 600 were used. Interestingly, only after adding PEG200 or PPG200, the suspensions still exhibited desired rheological and photocuring behavior, and the superior surface quality was still observed. More importantly, PPG200 proved to be the most effective plasticizer to achieve the most excellent and stable mechanical performances, as well as the highest debinding efficiency.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.