Effect of modifiers on morphology and thermal properties of novel thermoplastic polyurethane‐peptized laponite nanocomposite

Abstract

AbstractLaponite RDS (Laponite containing pyrophosphate based peptizer) was modified with cetyl trimethyl ammonium bromide (cLS) and dodecylamine hydrochloride (dLS), respectively. Thermoplastic polyurethane (TPU)‐modified Laponite RDS nanocomposites were prepared by solution mixing technique. Morphologies of these two modified clay‐nanocomposites are found to be markedly different. cLS based TPU nanocomposites exhibit partly exfoliated, intercalated, and aggregated structure at lower clay content but a network type of structure is observed at higher clay content. However, dLS based TPU nanocomposites demonstrate spherical cluster type of structure at all clay contents. Nearly two fold increase in storage modulus is observed in both glassy and rubbery state with merely 1% cLS content which gradually decreases with an increase in the clay content. However, in case of dLS filled nanocomposite, gradual increase in storage modulus is observed with an increase in the clay content. Thermogravimetric analysis (TGA) studies indicate that the temperature corresponding to 5 wt % degradation of TPU is enhanced by 19.1 and 12.5°C with the addition of merely 1% cLS and dLS, respectively. However, the activation energy of degradation of neat TPU, as determined by isothermal TGA analysis, is found to be higher than that of the nanocomposites containing 1% of cLS and dLS, respectively. © 2009 Wiley Periodicals, Inc. J Appl Polym Sci, 2010