Abstract
In this work, effects of Ethylene-vinyl acetate copolymer (EVA) and Dicumyl peroxide (D CP) on injection molding of recycled polyethylene (PE) materials obtained from a waste disposable drip tape are studied. Under injected at 175-230° C and 35-40 MPa, the recycled PE materials with EVA showed good injection moldability, while those with DCP showed poor injection moldability with DCP introduction increasing. Under injected at 135-145 ° C and 50-60 MP a, the recycled PE materials with DCP can be well injection molded.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
