Effect of Mn addition in W-Ni-Cu heavy alloy processed through hot press sintering techniques on microstructure, microtexture and grain boundary character evolution

Abstract

In this current study, the impact of manganese addition to 93 W-4.9Ni-2.1Cu-xMn (where x = 1, 2, 3, and 4 Wt%) on the microstructure, texture development, and grain boundary character distribution of tungsten heavy alloy (WHAs) was examined. The samples were produced through a vacuum hot press sintering, with parameters 50 MPa pressure, 10 °C/min heating rate, and 1450 °C sintering temperature for 20 min holding duration. To study the influence of manganese on the texture development and microstructure in conventional WHAs, electron backscatter diffraction (EBSD) was employed. The important findings from the EBSD analysis reveal that fibre texture (001) 〈111〉 and a higher fraction of low-angle grain boundaries in the Mn unalloyed compact resulted from extensive atomic jumps between the particles at elevated temperatures. Further texture analysis on the Mn-added compacts reveals that manganese oxide (MnO) formation during liquid phase sintering led to lower densification and randomized weak fibre texture development in manganese-alloyed compacts. In addition, the texture degradation in Mn-added compacts is mainly caused by recrystallization followed by sub-structural recovery during liquid phase sintering. This study indicates that increasing manganese content in WHAs stoichiometry led to a heterogeneous distribution of binder matrix (NiCu) in the sintered compact. As a result, W-4.9Ni-2.1Cu-4Mn alloy revealed decreased relative density (90.70%), microhardness (389.5 HV0.5), and electrical conductivity (15.74% of IACS).