Abstract
Abstract To effectively produce clean heat energy from biomass, microwave (mw) pre-processing of its different types - pelletized wood (spruce), herbaceous biomass (reed canary grass) and their mixture (50:50) - was carried out at the 2.45 GHz frequency with different durations of biomass exposure to high-frequency oscillations. To estimate the mw pre-processing effect on the structure, composition and fuel characteristics of biomass, its thermogravimetric (TG), infrared spectroscopy (FTIR) measurements and elemental analysis were made. The pre-processing is shown to enhance the release of moisture and low-calorific volatiles and the partial destruction of biomass constituents (hemicelluloses, cellulose), promoting variations in the elemental composition and heating values of biomass. The field-enhanced variations of biomass characteristics and their influence on its gasification and combustion were studied using an integrated system of a biomass gasifier and a combustor with swirl-enhanced stabilization of the flame reaction zone. The results show that the mw pre-processing of biomass pellets provides a faster weight loss at the gasification, and, therefore, faster ignition and combustion of the activated pellets along with increased output of heat energy at their burnout
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
