Abstract
The Sn–Mg eutectic alloy is a potential replacement for the traditional Sn-38.1 wt%Pb solder alloy, since lead has been banned because of its risk to human health and the environment. However, studies in the literature related to the Sn-2.1 wt%Mg alloy are restricted to mechanical, electrical and thermal properties. Therefore, this study aims to evaluate the corrosion behavior of this alloy, as a function of the microstructural arrangement obtained from directional solidification performed in a transient heat extraction regime. The thermal solidification parameters (solidification growth rate and cooling rate) were determined along the length of the casting for correlations with microstructural features. The resulting microstructure was characterized by scanning electron microscopy, energy-dispersive X-ray spectroscopy and X-ray diffraction. Subsequently, the electrochemical impedance spectroscopy, linear polarization, equivalent circuit and evolution of hydrogen release analyzes were performed to evaluate the corrosion behavior of the samples in a 0.5 M NaCl solution at 25 °C. Interphase spacing and Mg2Sn fraction were found to influence the corrosion behavior, showing higher corrosion resistance for a more refined microstructure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.