Effect of microstructure evolution on strength and impact toughness of G18CrMo2-6 heat-resistant steel during tempering

Abstract

G18CrMo2-6 steel is one kind of low alloy CrMo steel with ferrite/bainite phase constituent. It is widely adopted in the large casting parts of pressure vessels. This paper aims at investigating evolution of G18CrMo2-6 steel microstructure, tensile strength and impact toughness during the tempering (680°C). The tempered microstructure characterization shows that the tempering time mainly affects the precipitation of three kinds of carbides, naming MC, M3C and M23C6. Both tensile strength and impact toughness do not obey the monotonic evolution with the tempering time but the complex changes. The shift of mechanical properties results from the interaction among matrix phases and the evolution of three different kinds of carbides. The softening of matrix due to the dislocation recovery and the decrease of the amout of carbon and other alloy elements in matrix lattice due to the precipitation of M23C6 cause the decreasing tensile strength for the whole tempering except for that an increase during the short-term tempering controlled by the precipitation of MC and the spheroidization and refinement of M3C carbide. On the other hand, both the softening of matrix and the spheroidization and refinement of M3C carbide are responsible for the increasing impact toughness. However, the precipitation and coarsening of M23C6 at ferrite grain boundaries during long-term tempering results in the sharp deterioration of impact toughness. It attributes to the larger grain boundary carbides result in the lower critical fracture stress of a carbide-ferrite interface.