Effect of Mg Content on the Microstructure and Toughness of Heat-Affected Zone of Steel Plate after High Heat Input Welding

Abstract

The effect of Mg content on the microstructure and toughness of the heat-affected zone (HAZ) of steel plates after high heat input welding was investigated by means of welding thermal simulation test and insitu observation through high-temperature laser scanning confocal microscopy. It was found that with the increase of Mg content in the steel, the former austenite grain sizes were greatly decreased and the mainly microstructural constituents in HAZ were changed from the brittle constituents of Widmanstatten ferrite, ferrite side plate and upper bainite to the ductile constituents of intragranular acicular ferrite and polygonal ferrite. The proportion of grain boundary ferrite was decreased greatly with the further addition of Mg from 27 to 99 ppm. As a result, the HAZ toughness after welding with heat input of 400 kJ cm−1 is increased with increasing Mg content in the steel plate.