Abstract
The effects of membrane porosity and pore size on CO2 absorption performance and long-term stability were investigated using asymmetric poly(vinylidene fluoride) hollow fiber membrane contactors, prepared with differing inner surface structures by thermally induced phase separation. Membranes prepared using nitrogen gas as the bore fluid had lower inner surface porosity than membranes prepared with solvent. Monoethanolamine (MEA) solutions were used as absorbents on the tube side, while pure CO2 was supplied to the shell side. Gas absorption performance and long-term stability of the synthesized membranes were compared with those of a commercial poly(tetrafluoroethylene) membrane. The effect of surface properties on gas absorption performance depended on MEA concentration. A membrane with lower porosity and small pore diameter at the inner surface was stable for 200h, while a membrane with high porosity and larger pore size was completely wetted within 100h and flux rate decreased sharply.A mathematical model for pure CO2 absorption was developed by considering partial wetting of the membrane. The simulation results were discussed in light of the results from long-term stability tests of membranes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.