Abstract

We used a finite element (FE) analysis to investigate the biomechanical changes caused by transforaminal lumbar interbody fusion (TLIF) at the L4-L5 level by lumbar lordosis (LL) degree. A lumbar FE model (L1-S5) was constructed based on computed tomography scans of a 30-year-old healthy male volunteer (pelvic incidence,= 50°; LL, 52°). We investigated the influence of LL on the biomechanical behavior of the lumbar spine after TLIF in L4-L5 fusion models with 57°, 52°, 47°, and 40° LL. The LL was defined as the angle between the superior end plate of L1 and the superior end plate of S1. A 150-N vertical axial preload was imposed on the superior surface of L3. A 10-N/m moment was simultaneously applied on the L3 superior surface along the radial direction to simulate the 4 basic physiologic motions of flexion, extension, lateral bending, and torsion in the numeric simulations. The range of motion (ROM) and intradiscal pressure (IDP) of L3-L4 were evaluated and compared in the simulated cases. In all motion patterns, the ROM and IDP were both increased after TLIF. In addition, the decrease in lordosis generally increased the ROM and IDP in all motion patterns. This FE analysis indicated that decreased spinal lordosis may evoke overstress of the adjacent segment and increase the risk of the pathologic development of adjacent segment degeneration; thus, adjacent segment degeneration should be considered when planning a spinal fusion procedure.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.