Abstract

The role of the S-phase layer formed after low-temperature nitriding on the wear resistance of a 17Cr-10Ni-2Mo stainless steel at room and sub-zero temperatures was investigated by using an impact-sliding wear tester, simulating the progress of surface degradation on engineering components under dynamic loading. While the as-received samples suffered from plasticity-dominated wear, surface cracking was dominant for the nitrided samples. Both of the samples exhibited lower wear rates with decreasing test temperature. The highest contact pressure employed (3 GPa) caused spallation of the ∼3 µm thick S-phase layer at room temperature, unlike sub-zero temperature. Under this highest contact pressure, the thicker S-phase layer (∼6 µm) remained intact with the substrate and provided good protection against wear at room temperature.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.