Abstract
Due to their attractive mechanical, chemical, tribological, and biological properties, diamond-like carbon (DLC) coatings are widely used in many industrial applications. Normally, the deposition of amorphous hydrogenated carbon (a-C:H) films is obtained via the plasma-enhanced chemical vapor deposition (PECVD) technique. Recently, a modified pulsed-DC PECVD technique has attracted attention in this field due to its making it possible to grow a-C:H films at low-pressures (up to 0.1 Pa) in a collision less regime, leading to the achievement of improved mechanical and tribological properties. The incorporation of an additional cathode allows the confinement of electrons and ions, stabilizing and densifying the cold plasma at much lower pressure than conventional PECVD systems. This method is distinguished by higher energy and acceleration of the C+ ions, simpler reactor system equipment, and lower operating cost. In the present investigation, hydrogenated amorphous carbon films were grown on AISI 316 stainless steel using a thin amorphous silicon interlayer to improve interface adherence. The characterization of the coatings allowed identifying the influence of the deposition pressure on the microstructural, mechanical, and tribological properties and the film's adherence. The main results indicate that obtaining films with high hardness, low compressive stress, low coefficient of friction, high wear resistance, and appropriate adhesion is possible at deposition pressures almost 100 times lower than conventional PECVD techniques.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.