Effect of local mechanical oscillation on the performance of PCM thermal energy storage with various unit configurations

Abstract

The low thermal conductivity of phase change materials is an essential restriction to their usage in thermal energy storage units. In this research, applying local oscillation by an oscillator on the portion of a side wall of RT35 enclosure is presented as a novel method to enhance the charging rate. The finite volume method is conducted for the numerical study on the effect of different configuration parameters including enclosure aspect ratios in the range of 1: 6, 1:2, 1:1, and 2:1, various oscillator lengths of 5, 10, 15, and 20 mm, as well as different oscillation frequencies of 10, 100 and 1000 Hz on the melting performance. Results indicate that applying local oscillation enhances the melting rate by more than 50 % as compared to without using oscillator because of enhancing convection heat transfer originating from vorticity intensification. The improvement of required time for melting the PCM is 91.55 %, 54.66 %, 67.7 % and 71.4 % for aspect ratios of 1:6, 1:2, 1:1 and 2:1, respectively.Results show that the melting performance is enhanced as the length of the oscillator increases. The required time for complete melting is obtained equal to 24, 26, 28, and 33 min at the oscillator length of 20, 15, 10, and 5 mm, respectively. The finding on the effect of oscillation frequency reveals that the liquid fraction, mean temperature, and heat flux at a specified time of melting process becomes higher as the oscillation frequency increases with significant enhancement of vorticity around the oscillator. At the frequency of 1000 Hz, the required time for melting is reduced by 9.5 % and 20.8 % as compared to frequencies of 100 Hz and 10 Hz, respectively. Other results also indicate that the higher Nusselt number is obtained for a higher enclosure aspect ratio.