Abstract
Abstract Compact tension specimens with prefabricated cracks are repaired by laser with micro/nano materials added at the crack tip. Different combinations of laser parameters, i.e., laser power, laser spot diameter and heating time, were applied to investigate their effects on the microstructures and fracture properties of repaired specimens. J-integrals were calculated according to the digital image correlation (DIC) measurements, and microstructures were examined using scanning electron microscopy (SEM). When suitable laser parameters were used, homogeneous and compact equiaxed grains with no cracks, pores, and agglomeration are observed in the repaired layer, and the J-integral of repaired specimens is approximately 20% less than that of unrepaired specimen. The paper reveals relations among laser parameters, J-integrals, and microstructures, and provides a guideline for the selection of laser repair parameters.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.