Abstract
Abstract This paper aims to investigate the effect of laser ablation on the mechanical performance of graphene-filled glass fibre reinforced polymer (GFRP) repaired lap joints. The performance characteristics of repaired laminates were measured in terms of surface roughness, tensile strength and flexural strength according to ASTM standards. While the surface morphology was examined using a confocal microscope, scanning electron microscopy was adopted to analyse the laser ablated fibre–matrix interface. The average surface roughness significantly increased with an increase in laser power from 4 to 10 W which was attributed to the presence of graphene and burnt fibres. The laser ablation conditions corresponding to 10 W laser power, 300 mm s−1 scanning speed, 20 kHz of pulse frequency, 0.05 mm line spacing and 5 laser passes lead to the highest tensile strength (36.033 MPa) and bending strength (30.972 MPa) of GFRP laminates. The laser ablated microstructure was characterised by fibre pull-out, epoxy residue, burnt, clean fibres as evidenced by scanning electron microscopy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
